copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Reusing reclaimed refrigerant - HVAC-Talk So assuming I use clean, vacuumed recovery tanks, I can reintroduce the MO99 You use to recovery machine to pump it back in? I would have just used the filled recovery tank to put as much back in as possible and used the compressor as my pump And I would obviously have a good vacuum on the system beforehand Thanks for the replys
Cleaning a Recovery Cylinder - HVAC-Talk Hey everybody, What is the best way to clean a recovery cylinder if it was used for R-22 only and now I need to use it for r-134a? I don't want to cross contaminate the refrigerants? Is there a way to flush out the tanks or do I have to buy another one?
purging air out of a tank - HVAC-Talk Could you effectively purge air and moisture out from a recovery tank that has refrigerant in it (or charging cylinder) by bleeding some vapor out? [Edited by wannafreeze on 02-19-2006 at 11:07 PM]
Putting recovered 410a back into a system - HVAC-Talk Just be sure to pull your recovery tank to 200 microns or lower You can run the 410a through a drier between your recovery machine and the unit for extra moisture insurance
Removing air with recovery cylinder? - HVAC-Talk Recover the refrigerant and let it stabilize in the cylinder for a couple of hours Check the saturation temperature versus the tank pressure Very slowly bleed the air from the vapor port until they line up Placing the cylinder in water and measuring the temperature can also be used, it's a bit more stable than the air temperature
Air and the refrigerant recovery process. - HVAC-Talk If a system is leaking, generally refrigerant goes out because system pressures are higher than atmospheric pressure There are some exceptions, such as chillers which run below 14 7psia (0 psig) IIRC, regardless of the recovery system, for type 1 and 2 systems (not chillers), if there is a leak, you are not required to recover below 0 psig (atmospheric pressure) as this would indeed draw air
Recovery cylinders | HVAC-Talk: Heating, Air Refrigeration Discussion 45 3 (refrigerant wt ) + 27 6 (tare weight) = 72 9 max tank gross weight* *Note: WC and Tare weights will vary with different manufacturers of recovery cylinders, and those actual numbers for each cylinder should be used in applying this formula
Problems with recovery tank - HVAC-Talk Yes, for the recovery first to commission the tank I've heard some are shipped with nitrogen in them Mine wasn't What kind of refrigerant is in the tank? What is the ambient temp of the tank ? 120 psi seems low for outside in the summertime for R22, and for sure 410A Also, how did you check the psi of the tank? I'm assuming your manifold?
Recover and weigh in with an empty recovery bottle - HVAC-Talk Here is the dilemma: I recover 24 Oz of refrigerant in the recovery tank, Now I want to charge the 24 Oz back using the liquid valve of the recovery bottle, positioned upright as a liquid - at least in theory It is unknown to me how much of those 24 Oz were liquid at the tank bottom or were vapor form atop of it
recovery tank capacity - HVAC-Talk 410a recovery tanks are different then tanks for r 22 Not anymore, at least from the suppliers in my area All the new tanks we have been getting back from our suppliers are rated for 400psi, so can be used for R-410a