copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
4086 page 1 Slide the Square Nut Plates in place and position at rear of bed, install 1” bolts and washers according to diagram below and position the bracket according to the chart on reverse side Form # AS4086II For Warranty Issues, Contact UnderCover Directly Created March 2012 (866) 900-8800 www undercoverinfo com
2146 page 1 Model 2146 Ford F150 Ext Crew Cab 5 5’ Short Bed 2009-Current Note: This Cover will work with or without a tailgate step Form # AS2146II For Warranty Issues, Contact UnderCover Directly Created March 2012 (866) 900-8800 www undercoverinfo com
INSTRUCTIONS - undercoverinfo. com INSTALLATION INSTRUCTIONS CUSTOMER SERVICE Phone: 866-900-8800 • 8:30 am - 5:00 pm Mon - Fri CST Email: info@undercoverinfo com RealTruck UnderCover
PRODUCT CATALOG - undercoverinfo. com The UnderCover Flex is a hard-folding truck bed cover that gives you the ultimate control of your truck bed, offering three secure riding positions The cover is easy to remove, requires no drilling for installation, and is mounted flush with your trucks bed rails
1070 page 1 The t of the cover to the truck bed is determined by the front mounting brackets This measure-ment is a good starting point Unfortunately not all truck beds are assembled 100% square, so some adjustments may be necessary after the cover is set on the truck
1096 page 1 Model 1096 GMC Sierra Std Ext Crew Cab 6 5’ Short Bed 2007-2013 (also ts 2014 Sierra 2500hd) Note: If your truck is equipped with a spoiler style tailgate piece, you will need to replace it with a standard smooth style tailgate piece like the photo to the left
SELECT INSTALLATION - undercoverinfo. com 1 cover (A) by cleaning the top of the bulkhead with soap and water to remove dirt and debris Clean the area with isopropyl alcohol to remove wax or grease and to evaporate any remaining water Allow the surface to dry Peel the backing and adhere the seal from one bulkhead edge to the other Remove any excess with scissors or a utility knife Apply pressure evenly to the entire seal to