copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
ACME PROP REPAIR - CorrectCraftFan. com Forums It went to Mikes Prop shop He is local to me I had the first 540 he repaired Had to wait 2 weeks for him to get the dies to pound on Let me know if you need a Phone # I went thru a friend who owns one of the local shops and got it done for half the price I was quoted over the phone He does OJ's as well I got to know him real well by the end of last summer as the lakes were very low around here
prop recommendations - CorrectCraftFan. com Forums - Page 1 Your Prop is not seated into your shaft Buy some valve lapping compound, spread a little around on the shaft taper where the prop sits, put a little in the prop also Mist it with a little water then put the prop on the shaft with no key way in place Spin it on the shaft while gently moving it forward Keep doing this for several minutes
Brass Prop Repair - CorrectCraftFan. com Forums When I bought my boat, the prop was a little dinged up on the outside, and a little material missing toward the center I had it redone locally at a reputable shop in Maine I also bought a new one and although they did seem to do a pretty nice job on the old one, the new one (identical repalcement) gets me about another 3 mph and is smoother
Prop selection 82 Ski Tique - CorrectCraftFan. com Forums A lot of that can be attributed to the roller though 4k RPM sounds like its either underperforming a good bit, or has too big of a prop on it Prop it to run 4400-4600 (if stock) and it will perform much better, both down low and up top The stock peanut port heads and low compression ratio wouldnt have it responding very well to a big stick
Prop Shaft Came out of Tranny - CorrectCraftFan. com Forums 1 Bent shaft: Take the shaft and prop to a prop shop (or send it) They can check out the shaft and maybe straighten it Or if not, sell you a replacement 2 Bent prop: You already know this, so see above 3 Bent Strut: You are probably ok here, but take a close look and if you suspect it is bent, also send to prop shop 4