copy and paste this google map to your website or blog!
Press copy button and paste into your blog or website.
(Please switch to 'HTML' mode when posting into your blog. Examples: WordPress Example, Blogger Example)
Input Form:Deal with this potential dealer,buyer,seller,supplier,manufacturer,exporter,importer
(Any information to deal,buy, sell, quote for products or service)
Why breaking in a barrel is NOT necessary - Snipers Hide Re: Why "breaking in" a barrel is NOT necessary The reason that the barrels change velocit is the bore actualy work hardens and if you fire yout rifles at say 500 yards you can see an elevation shift somewhere around 50 to 80 rounds then they usualy settle down the reason to break in barrels is to smoth out the burs in the throat
Is brake fluid change really necessary? | Honda Accord Forums - The . . . I was reading through the manual for our 2014 Honda Accord and noticed it recommended replacing the brake fluid every 3 years I have owned three Hondas (1990, 1995, and currently a 2004) that all had have over 250,000 miles I have never done anything with the brake fluid with those three cars
Is flushing the coolant system necessary? | Honda Accord Forums - The . . . In my opinion using distilled water to flush is a bit overkill Also, insisting on Honda coolant is a fine but not necessary if you are flushing the whole system (be sure to get the heater core) If you have a air bubble the engine will not circulate coolant properly and may overheat
Necessary twist for . 308 175gr. . . ? | Snipers Hide Forum Re: Necessary twist for 308 175gr ? You should be fine with 175SMK's I wouldn't recommend 1:12 as the best for anything longer than that though (11 25 or less for VLD Amax types)
Brake dust shield fell off. Is this a necessary part? Good evening Accord Drivers, My car's wheel was making noise while driving yesterday and it was getting worse I saw that the brake shield was coming off and finally came off this morning Is this a necessary part or can i do without it
When to use an expander mandrel; is it even necessary? I use a turning mandrel in place of the expander button on your decapping pin with the idea that it produces less runout than the expander button In short, I have a Dillon 550 and the first station is a F L sizing die with no decapping pin or expander button The second station is a carbide turning mandrel This mandrel is intended to create more even neck tension by expanding all the necks
308 Win chambers. Is a match chamber really necessary? It has been decades since I had an action rebarreled When ordering a barrel to be installed, there used to be match chambers and standard SAMMI chambers for the 308 Now I am seeing Alfa neck reamer size as a sort of in between With a good 5R barrel, is there really any reason to go with