|
- Mega timers - Programming - Arduino Forum
The PWM pins are shown but I can't find which timer controls which PWM output I need to change the PWM frequency of the PWMs I use if needed I need a PWM frequency of about 31kHz and need to setup the appropriate timer control register for that (I use 10 PWMs of the Mega and need to make sure the correct frequency gets to the correct PWM)
- Making a timer - Programming - Arduino Forum
Hello, I am making a Timer with my LCD Display I do not have any input connected at this point in time I am trying to make my timer display count down but I do not know how I can do this I was hoping someone may assist me with the coding of this I have not touched arduino in a while so I am a little dusty
- Timers on the Arduino Mega 2560
Hi all, I am contemplating a project where I would want to have three independent timer interrupts running simultaneously and want to understand how the Arduino platform uses the timers on the Mega (ATMega 2560-based boards) As I understand, the ATMega 2560 has four 16-bit timers available and two 8-bit ones Ideally I would like to hijack three of the 16-bit timers My question is, I know
- Use of Timer 2 in Arduino UNO
Iam beginner with arduino and learning Interrupts , Stuck at a point while doing my project , I want to know how to use timer 2 for interrupt , i wrote a small peace of code , after every 10ms i want to monitor a sensor input
- Temporizador con Arduino sin usar funcion delay ()
Hola, Me gustaría hacer un temporizador con arduino y un relé conectado a el El caso es que quiero poder temporizar la duración que va estar encendido (HIGH) y el tiempo que va a estar apagado (LOW), pero esto tiene que ser sin usar la función delay() ya que hago mas cosas con la misma placa y no puede estar interrumpido por la funcion delay() La idea es algo así: long tiempoON = 60000
- 4 Temporizadores usando millis - Sem delay () - Arduino Forum
Senhores, bom base em alguns exemplos da internet desenvolvi esse Sketch, mas estou tendo algumas dificuldades, visto que sou novo a área, portanto peço ajuda de vocês Preciso adicionar o reconhecimento de um 2º PULSO vindo da mesma entrada do 1º PULSO e também adicionar um atraso - sem a função delay() para o 4º led (LED4) Usando a função millis() consegui os temporizadores Se
|
|
|