|
- IAquaLink variable speed schedule - Trouble Free Pool
Thanks so much I will go in and adjust my vsp settings speed 1 to the lowest @ajw22 can you tell me why if I schedule a different schedule name other than filter pump (speed1) the pool temp sensor isn't active? I assume since its the main pump running it is flowing through the temp sensor and the filter etc and acting just the same as "filter
- Variable Speed Pump and Chlorinator Settings - Trouble Free Pool
Should I be running my VSP 24 hours a day 7 days a week? If yes, what should my settings be for the maximum savings? (Duration and RPMs) If no, how long should I run my VSP, at what RPM, and at what should I set my SWG % to ensure it is getting enough chlorine? Any additional thoughts you have and want to include is greatly appreciated!
- VSF pump speed - GPM vs RPM - Trouble Free Pool
On a VSP why would I use RPM instead of GPM? 2) Currently going through pool school (pool is brand new), reading a ton about adding chemicals and setting a higher flow rate or running the pump 24 7 vs less often Our pool builder set the pump to run 24 7 at 55 GPM on the pool, heater, and cleaner (3 different settings but all set the same)
- Connecting Hayward Goldline 235 Solar Control to Tristar W3SP3206VSP
Hi My TRISTAR VSP (W3SP3206VSP) arrived yesterday for my (hopefully) "drop in" Ecostar VSP replacement Hayward training videos and others online are for older model Tristar VSP's with different physical configurations and not helpful The Tristar VSP piping match to the installed ECOSTAR
- Century VGreen EVO VS Pump Motor Aqualink - Trouble Free Pool
The VSP motor must see a poll before it can respond back Once you tell the RS that a VSP pump is out there (via the VSP setup page) the RS begins polling the motor’s address, and then the Century Connect can see the polling and figure out what system it is attached to
- iaqualink schedule help - Trouble Free Pool
First time pool owner here Im having a hard time getting iaqualink to run a schedule that changes the speed of my variable pump The pool is a small 8000 gallon pool and I run the pool pump (filter pump) for 12 hours per day The schedule Im attempting to run looks like this: 8:30 am -
- iAqualink programming question - Trouble Free Pool
I have what I hope is an easy question re programming my iAqualink 3 0 I have a Jandy VSP ePump, 600-3450 rpm Filtration schedule set to run at 2000 most of the day with two periods of 2800 rpm to help with skimming All of this works fine We have "water features" (spa overflow, scupper)
- Hayward Tristar VS setting through OmniPL | Trouble Free Pool
Hello I have a Hayward Tristar VS 900 pump controlled through OmniPL I'm trying to set the maximum RPM and pump prime duration When I disconnect my OmniPL data link from the pump and reconnect the on-pump control panel, I can access the Configuration menus and make the setting adjustments
|
|
|