|
- Hayward Tristar 900 vs Tristar 950 VSP | Trouble Free Pool
Looking to upgrade from a single speed pump to a Hayward vsp My liquid chlorine plaster pool is around 20k gallons and has one skimmer rated at 55gpm Filter is Hayward DE 6020 and heater is Hayward 400K In the not too distant future I plan on installing an Aquarite S3 Omni system Should I go for the 900 or 950, and for what reasons?
- VSP Derby New Frequency 460. 375 - RadioReference. com Forums
VSP Derby is now transmitting primarily on 460 375 453 900 and 460 150 are used infrequently, possibly due to the mobile units location One Saturday night in early July the dispatcher for ST Johnsbury was handling all of the VSP communications in Orange, Caledonia, Essex and Orleans while
- How to set VSP pump speed schedule in iAqualink?
Hi all New pool owner trying to find my way through the automation system I can't seem to find where I can set the speed schedule in my iAqualink automation I have a Jandy variable speed pump and would D like to run the pump faster at some times of day than others in a schedule automatically
- IAquaLink variable speed schedule - Trouble Free Pool
Thanks so much I will go in and adjust my vsp settings speed 1 to the lowest @ajw22 can you tell me why if I schedule a different schedule name other than filter pump (speed1) the pool temp sensor isn't active? I assume since its the main pump running it is flowing through the temp sensor and the filter etc and acting just the same as "filter
- OmniLogic not detecting HUA for Hayward VSP - Trouble Free Pool
I just installed the new Omnilogic Control Panel When I try to configure the VSP, it does not show up in the list of detected devices It appears that the OmniLogic panel is unable to "see" it and therefore unable to obtain it's HUA High voltage wiring is directly to the breaker Low voltage
- Pump not working Hayward Omnilogic Alert: MSP_DEV_COMM_LOSS,Comm Loss . . .
Yesterday morning while I was out of town I started getting alerts for my pool (a fiberglass Aviva Lux 40) I received two different alerts: MSP_DEV_COMM_LOSS,Comm Loss Device:VSP HUA:10-01-17-65-99 Reason:No Water Flow FlowSensor this is our second summer with the pool and learning as I go
- Adding Variable Speed Pump to existing Aqualogic automation system
Controls pool, spa and gas heater Ideally, i would like to install a new VS Pump and use as much of my automation system as possible My concern is that the Hayward VSP only work with Software Rev 2 65 and above Is there an upgrade to my existing system, or would i have to replace? If no upgrade, should i go with a 2-speed pump replacement ?
- Hayward OmniPL MSP_DEV_COMM_LOSS,Comm Loss Device . . . - Trouble Free Pool
Hello, thank you in advance for looking at my thread and trying to assist with sorting it out I have a Hayward system with an OmniPL automation box, two Hayward Tristar VSP 950 pumps (One for filter, one for waterfall), and various other Hayward devices (lights via low high voltage to low
|
|
|