|
- Summa F1612 Bed Vacuum - Signs101. com: Largest Forum for Signmaking . . .
Setting the size in Summa Axis Control: It concentrates the suction to the smaller piece's width along the right side (origin side) It does not work for length so that option is useless- I talked to the tech who set ours up He said its basically 1 wall that moves inside from the left (wider materials) to the right (thinner)
- Surfacing MDF Spoil board issue - signs101. com
Everything was going great until it got about 10" from the outer edge and the corners started to lift a good 1 4"-3 8" We started the surfacing in the center and cut outward My assumption is it had a surface tension issue that caused the whole board to buckle and it lost its suction from the vacuum table Needless to say it ruined the sheet
- White dots splashed when printing UV Printer
- More white dots appear on the part of the material that is closer to the suction station Near the suction station there seems to be a lot of white ink splashing - I have already checked the height (the printer detects it automatically) - The nozzle test is generated correctly
- Need Help Air in Majenta line and pump not sucking ink
If that doesn't work, the reverse it and suction from the top and push from the bottom Also, make sure that the air tube that is under the cap top is not stopped up with dried ink While the cap top is off, push some cleaning fluid backwards through the 2 tubes that are under the cap top
- Need Help Mounting aluminum sign to glass door - Signs101. com: Largest . . .
Suction cups? Is it temporary? I would use mounting tape and silicone and apply something to the back of the glass to hide the mess, either a matching piece or vinyl
- JV33 capping station seal issue? New cap top, pump base. How to align?
Tightening the hex screw did create better suction or seal on the capping station(!) -- however, I need to adjust it properly tomorrow by loosening the lock screws first and really adjusting the bed There is also an [HASHTAG]#ADJUST[ HASHTAG] > CAPPING setting which you can adjust to snug the head parking location farther to the right
- Solution for magnetics, on aluminum trucks
I hate magentics I typically talk most clients into not getting them and just doing direct surface vinyl or print But I have these FWS Gator Trappers, that use their personal trucks and just absolutely have to have the ability to remove and put back on their vehicle signage Just had the
- Gerber Sabre 408 Spoil Board Sacrificial Table
Hello guys Another Christmas break and we are still trying to improve the suction on our spoil board to be able to hold down smaller parts better For substrates thicker than 1 4" the suction is adequate but not great With 1 8 and 3 16 thick substrates small parts move around and we have trouble cutting them
|
|
|