|
- Mini 3 Pro - Replacing rear motor without opening a drone
Hello I need to replace both rear motors I don't want to disassembly whole drone, so I'm thinking about pulling out the motor from the arm, cut the wires and solder new motor I know this is possible, because I pulled my motor out, but I'm worried about antenna and it's signal wire, because
- Gimbal screws and replacing bracket on - DJI Mavic, Air Mini Drone . . .
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely I am also looking for replacement Philips 1 screws for the gimbal internals does anyone have the specs on the screws?
- Are Autonomous Drones Replacing Human Pilots? (By Timothy Brazzel)
Are Autonomous Drones Replacing Human Pilots?Joined Oct 28, 2021 Messages 820 Reactions 944 Location Los Angeles Site www thedroningcompany com
- Replacing vehicle alternator warning lamp with LED
I'm sure that this must have been done numerous times in the past, but I'm darned if I can find any definitive description of how to do it anywhere As the title suggests, I'm trying to figure out how to replace an alternator warning lamp with an LED There are a couple of issues it seems: many
- Replacing MOSFET, what to look for | Electronics Forum (Circuits . . .
Hello forum, I'm replacing the MOSFETs in an Electronic Speed Control (ESC) for RC cars My problem is, I don't really know what to look for when choosing the new MOSFET The current rating of my MOSFETs are all higher than the old ones in the ESC I'm more interested in the gate charge
- Motor or ESC board failure? How can I tell? - DJI Mavic, Air Mini . . .
Replacing the ESC board is the single toughest repair on a Mavic, but the OP shows that it can be done Just be careful with all tee ribbon cables, dont damage them, and also dont let solder or flux splatter on to adjoining components If that happens, you will get a short, and might never be able to identify it
- Replacing the gimbal cable (not the gimbal camera unit ribbon)
Taking off the gimbal bridge cable is the easy part Stripping down the gimbal is the hard part I have done many You have to thread the broken cable down through the hole in the gimbal motor assembly, remove all 3 glued motor covers with a heat gun, remove the camera barrel from the gimbal motor assembly, and replace the LVDS ribbon cable
- Replacing an IRF520 with a more durable Mosfet | Electronics Forum . . .
I have a 10meter Ham rig that is running 8 IRF520's in the amplifier section The 520's don't take abuse to well especially if running at sustained intervals for CW operation I was wondering if something like the IRF540 fet could be used as a direct replacement and if it would be a bit more
|
|
|