|
- Gimbal screws and replacing bracket on | DJI Mavic, Air Mini Drone . . .
I have put back together the entire gimbal already, and I would much rather superglue a plastic piece to the motor than fully disassembling the gimbal again and replacing the motor entirely I am also looking for replacement Philips 1 screws for the gimbal internals does anyone have the specs on the screws?
- Replacing vehicle alternator warning lamp with LED
I'm sure that this must have been done numerous times in the past, but I'm darned if I can find any definitive description of how to do it anywhere As the title suggests, I'm trying to figure out how to replace an alternator warning lamp with an LED There are a couple of issues it seems: many
- Replacing MOSFET, what to look for | Electronics Forum (Circuits . . .
Hello forum, I'm replacing the MOSFETs in an Electronic Speed Control (ESC) for RC cars My problem is, I don't really know what to look for when choosing the new MOSFET The current rating of my MOSFETs are all higher than the old ones in the ESC I'm more interested in the gate charge
- How can I use resisters to replace a Thermister?
If replacing the control board cures it, then obviously the control board is faulty What does the thermistor read between ST-SR, that's the rather crucial part you've left out - presumably (as the other two both read the same) they 'might' be connected together, so should read zero ohms (or very low) If it reads 30 62, then there's possibly two thermistors? But I don't see how replacing the
- Replacing a 3. 7v Lithium with a Fixed Power Supply?
Normally, I have one of those dash camera systems in the car In addition to drawing power off the car's 12V lighter port, the recorder contains a 3 7v 1100 mAh lithium ion battery I suspect our recent wave of hot weather damaged the battery, because a couple days ago I found the recorder
- Replacing front leg mini 2 se | DJI Mavic, Air Mini Drone Community
I'm replacing the left front leg I can't get the spring loading to work Leg just flops around Any help?
- Replacing capacitor LED Driver | Electronics Forum (Circuits, Projects . . .
Hi In my 220VAC LED lamp 40W the driver suddenly stopped working, after inspection i found out that the capacitor 400v 15uf was burned The part of the circuit is like 220VAC input -->4 diodes ---> to 400v 15uf cap and then the rest of the circuit which i do not understand but looks very
- Replace downward sensors | DJI Mavic, Air Mini Drone Community
Does anyone have experience in replacing the two sensors down? mine display black screen during calibration test I think they got wet
|
|
|