|
- sockets - recv () in Python - Stack Overflow
Once recv() returned b"" you won't receive anything from this socket The interpretation of "the client (a human) just presses enter" depends on the client (software)
- Python Socket Programming: recv and recvfrom - Stack Overflow
I am new to python and socket programming, and I'm confused about about usage for socket recvfrom() and socket recv() I understand that people usually use recvfrom() for UDP and recv() for TCP
- Recv failure : Connection was reset git - Stack Overflow
Problem: But when I try to clone a repo I get "fatal: unable to access xxx : Recv failure : Connection was reset, git " I have also enabled git trace to debug it and here are the results
- Python Socket Receive Large Amount of Data - Stack Overflow
TCP IP is a stream-based protocol, not a message-based protocol There's no guarantee that every send() call by one peer results in a single recv() call by the other peer receiving the exact data sent—it might receive the data piece-meal, split across multiple recv() calls, due to packet fragmentation You need to define your own message-based protocol on top of TCP in order to differentiate
- Isnt recv() in C socket programming blocking? - Stack Overflow
In short: yes, it is blocking But not in the way you think recv() blocks until any data is readable But you don't know the size in advance In your scenario, you could do the following: call select() and put the socket where you want to read from into the READ FD set when select() returns with a positive number, your socket has data ready to be read then, check if you could receive length
- C C++ sockets and a non-blocking recv () - Stack Overflow
In non-blocking mode recv will return immediately if there is zero bytes of data to be read and will return -1, setting errno to EAGAIN or EWOULDBLOCK The upshot is that normally you will call recv in a loop until you get the amount you want while also checking for return codes of 0 (other side disconnected) or -1 (some error)
- sockets - How C++ `recv` function acts at data receving? Could it . . .
Each recv () will return number of bytes received, and receiver can advance buffer pointer by that number of bytes so the next recv () writes into free part of the buffer Btw, this shared knowledge (contract) between client and server (or receiver and sender) is your communication protocol at the application level
|
|
|