|
- The printer shows that AMS filament ran out | Bambu Lab Wiki
After confirming that the remaining filament has been removed or cleaned, feed a new spool of filament into the AMS to allow the machine to continue printing If you encounter difficulties in the above operation process, please create a ticket to contact our after-sales support team
- What happens when you run out of filament? : r BambuLab - Reddit
If it runs out of filament, it will pause If the filament stops feeding due to a kink in the filament, it keeps running The printer only knows if filament is present or not, it does not detect feeding of the filament (non-AMS)
- Never Run Out of Filament Mid Print - How to Use Auto-Refill on Bambu . . .
Here’s how to set up auto refill, whether it’s from the same filament to the same filament, or even if you want to switch to another filament type when the current one runs out
- How to fix filament issues caused by unlocked spools
If the filament spool becomes detached during use and the spool filament cannot be put back, you can refer to this guide to fix the filament Note: This article is not applicable to when the filament is completely scattered apart
- What Happens When Bamboo Runs Out Of Filament
The Bambu Lab P1S 3D printer features advanced technologies, including a Filament Run-out Sensor which detects when filament is depleted during printing, allowing for a smooth filament change and uninterrupted printing
- Don’t Panic! What to Do When Your A1 Mini Runs Out of Filament Mid . . .
Don't panic if your Bambu Lab A1 Mini runs out of filament mid-print! In this video, we'll show you what to do when you encounter a filament runout on your A1 or A1 Mini 3D printer
- How to change the filament while printing is in progress
If you have a spool with tape you need to be there to just cut the filament before it gets to the bitter end, let it run out, and it should prompt you Even with the tail of the old filament not taped, it’s good to cut that little bent nubbin off instead of letting it go down the tube
- Filament may run out close to the end of my current print . . . - Reddit
I did some number crunching and it looks like the spool may run out in the last few layers I have an extra spool, so I was wondering how can I pause the print, change the filament, and resume the print?
|
|
|