|
- record and stream video from camera simultaneously
The tee command reads from standard input and copies to any number of files plus standard output by default, see man tee for more details
- How to connect Raspberry to two Wi-Fi different networks simultaneously
The answer is yes to both questions -- or at least, you can add one usb wifi and use that and the onboard one simultaneously You may notice that one or both connections slow somewhat (I have a Pi that does this regularly for a few hours, but the slow down is just a suspicion I have not investigated to confirm)
- python - monitoring two serial ports simultaneously - Raspberry Pi . . .
For my project I need two serial ports and I need to monitor both and act accordingly Example of what I need to do: Port A and Port B Monitor all the time Port A and when message is received, I ne
- How to drive two stepper motors simultaneously
I encountered issues when adding a second motor The GIL does not allow for both threads to run simultaneously Mi solution was to add a centralized stepping class (Navigation) and have it ran by a dedicated python process (so your app does not compete) The readme shows how to initiate the motors I ise a motor Hat with two DRV8825 onboard
- Unable to Use Arducam IMX708 and Arducam ToF Camera Simultaneously on . . .
I followed all instructions from the Arducam documentation to set up and run the ToF camera I used Picamera2 to configure the IMX708, and it works fine independently However, running both cameras simultaneously does not work, and I have to modify config txt each time to switch between them
- Can RPi4 run simultaneously on dual band (WiFi 2. 4GHz 5GHz)?
Yes, it is possible to run a RPi 4B simultaneously on dual band (WiFi 2 4GHz 5GHz), but only with predefined interface combinations given by the hardware If one interface is used as access point (AP) you can only use one band First to clarify: you are talking about RPi 3B, the link you have given is talking about a RPi 3B+ This is an
- rpi. gpio - Control motors and servos simultaneously (Python . . .
I have a Raspberry Pi 2B+ and some knowledge of Python I need to control a DC motor, two servos and a LED simultaneously The requirements are: Must control two servos, a LED and at least 1 DC motor (obviously) Must be compatible with the Raspberry Pi 2B+ (obviously) Must be controllable through Python and GPIO
- Using two SPI ports simultaneously on Raspberry Pi 0 W
Question Trying to use two SPI busses on RpiZW Put a line on boot config txt to enable it "dtoverlay=spi1-3cs"
|
|
|