- starting problem, keep cranking for long time . . . - Dodge Nitro Forum
Anytime my fiancés nitro was warmed up it took 5-6 seconds of cranking to start I replaced it 2 days ago and and it's fired right up every single time since then
- Lift Kit build | Dodge Nitro Forum
Rocky Road still sells a couple different lift kits They have their Rockfather kit, which is a mix of their own stuff, and OME stuff: Dodge Nitro Lift Kit: Dodge Nitro Lift Kit, 3" lift Then they have a full Old Man Emu kit, that they say is for the 08-12 Jeep Liberty, but should fit fine: Jeep Liberty OME: 2008-2012 Jeep Liberty OME Lift Kits Rocky Road also sells their own control arms
- Hemi swap - Dodge Nitro Forum
the Hemi would need it's ECU, the Nitro's would need to keep it's PCM for the TIPM and all the Nitro's electronic modules work, getting the Hemi electronics to play nice with the Hemi electronics, that is a big challenge, on the SEMA Nitro they didn't even manage to get the windows working,
- PCM wire and connector location - Dodge Nitro Forum
I have a 2011 Dodge Nitro SE 4WD 3 7, and the Engine lights are on, showing PO300 I replaced ALL spark plugs, the ignition coil, the spark plug wire, the fuel injectors, and even the EGR valve
- 3. 7 Engine Torque Specs Needed - Dodge Nitro Forum
This will be on a 2010 Dodge Nitro 3 7 4x4 Are the above torque specs the same for this year? I am new to this as well What is the preferred sealant for the head bolts Does anyone know of a site I could get all the torque specs? Head bolts, exhaust manifold, front timing cover, ect? Any feedback will be greatly appreciated
- 2007 Nitro Blend Door Location - Dodge Nitro Forum
Hello can anyone tell me where the blend door actuator on my 2007 is ? It sound's like it is behind the stereo ? is it a pain to get to ? thank's in advance
- Oil Pressure Switch Location - Dodge Nitro Forum
I have a 2008 Nitro with a 3 7L The oil pressure switch is located directly above the oil filter in the front of the engine You need a 1 - 1 16 deep well socket to remove it The electrical connector going to it has a locking tab that is red
- No Heat Issue - Dodge Nitro Forum
Fired up the Nitro this morning and there doesn't seem to be any heat coming out of the vents! The blower works on all speeds but there doesn't seem to be enough force blowing out, even on high, and the air in the middle vents under the windshield are warmer than the outside vents Looks like it's time for a battery unplug reset, coolant check and possible blend-door accuator replacement
|