|
- Spread axle- pros cons - Yellow Bullet Forums
Spread axle will scrub the tires much harder However, they're easier on the tow vehicle, because the axles support the weight over a longer area, which means less porpoising They ride a bit better, as a result of the axles working more independently or less "together" Backing a spread axle is much more difficult, due to the weight distribution being spread so far apart If you encounter
- Main and Rod bearing prep - Yellow Bullet Forums
Housing bores and the back side of bearing shells can be cleaned with alcohol prior to assembly ACL bearings are manufactured in Australia Clevite is still manufactured in Nebraska, USA but that is in the process of being changed, to Mexico in the very near future
- Whats a good size winch for car trailer? - Yellow Bullet Forums
Hi, I'm looking to buy a winch for my trailer, my car weighs 3000 pounds What would be a good size winch to pull the car up onto the trailer? Im using a 2500 now and it struggles There's a sale on 5000 pound winches and the next size up is 9000 What are you guys using? Thanks!!
- Freight shipping an engine | Yellow Bullet Forums
When Nebraska closed I went direct to HQ in SLC because they called me about the closing That deal was 2 vidmar cabinets from Brooklyn to Lancaster, the phone guy talked me into using YRC against my better judgement because they were $25 less than the next carrier Quote was ~$250 for 2 pallets with Vidmar cabinets on them
- open trailer wind delfector - Yellow Bullet Forums
anyone know where to get a nice , yet inexpensive wind screen deflector, for an open trailer ? I've seen some neat ones going down the hwy, where'd they get them? looking to protect the car on the trailer Not looking for 6 ft tall, 3-4 ft tall, aero design
- 65 Nova “Patina” Small Tire Build | Yellow Bullet Forums
This is our 65 Nova home built small tire Hot Rod This was a rust bucket we found sitting next to a barn on a farm out in Nebraska We brought her home and fixed every bit of rust, knocked out all the dents and blended in the paint to match the original patina as we found her We bent up the
- Blue Print Engines-any good? | Yellow Bullet Forums
Looking for an aluminum headed engine for one of my cars Looking at Summit it appears the Blue Print engines are not to badly priced Anyone have any experiences with them? Thanks Randy
- holeshot wheels | Yellow Bullet Forums
Fox, it was most likely me you spoke with at the track Yes, they have stood up to wheel stands from the best, just ask Fiscus or Kenward Holeshot Wheels are very strong while being one of the lightest strip wheels available They are made for the track and we don't recommend them for the street but I have seen many on the street over the years May I suggest Mrhockey, Holcomb motorsports or
|
|
|