- Moog Forum
Home Categories Guidelines Powered by Discourse, best viewed with JavaScript enabled
- How do you pronounce Moog and MoogerFooger
I have heard two ways to pronounce this: ‘Moog’ rhyming with ‘rogue’ and ‘Moog’ rhyming with ‘coug’ (short for cougar) And how do you pronounce ‘moogerfooger’? It seems like that would be pronounced with two ‘oo’ or lon…
- New Muse Owner - Moog Muse - Moog Forum
Hi, Just thought I would make my announcement to the Moog Muse world I am now, finally, a proud Muse owner - I had to wait a long time due to supply issues in UK, but it is here now I am a long time synth addict (both hardware and software), long time Yamaha fan (TG77, EX5,R, Fs1R, AN1x, Montage M7 still in the studio) and Korg Kronos to cover the Korg side of life, but over the past few
- Messenger knob panel calibration? - Moog Messenger - Moog Forum
I’m loving the sound features of my new Messenger, but the knobs don’t seem to be calibrated correctly: With bipolar control knobs, the neutral position isn’t at the center noon position This is most noticeable with everything to do with oscillator pitch For example, the neutral (A = 440) position of the tune knob is about 1 degree clockwise from the noon position The neutral
- state variable VS ladder filter - Moog Music
The Moog ladder filter was a patented design for years, and is known for its ladder design If you’re just making a filter that slightly overdrives the signal, you might as well call it a “filter,” without making reference to the circuit design that so specifically references another filter, with a very distinctive sound
- 904a Ladder Filter - Moog Music General Topics Forum - Moog Forum
Hi, I’m just on cloning the 904a Low Pass Filter and I have a question Can anybody tell me the resistor values of R25 (trim pot) and R45 (R 47 ???)of the 1967’er schematic? (See red circle below) The resistors are located in the current sink below the first filter pole Perhaps one of the lucky owners of an original module can help me Thanks in advance Carsten
- Moog VCO which modern equivalent?
According to the Moog System 15 sales literature: the 921B has a frequency range from 1-40,000hz the 921 has a frequency range of 01 to 40,000hz 921b AC and DC coupled frequency control imput jacks-linear responce 921 3 frequency control input jacks-exponential responce Kevin, Im not contesting you, im just quoting what the literature says
- DIY Moog Ladder Filter Help?
Hello everybody! After a little over an hour of searching through these forums, I haven’t gotten a hit that’s relevant to what my situation is I am wanting to take a schematic for Moog’s ladder filter and build it myself to add to a little Arduino-based setup I’m trying to build I’m pretty sure this is a little out of my abilities to pull off easily, but I’m going to give it a
|