|
- Which TB?? Oil Cooler? - GalantVR4. org
I want to get a second throttle body to eliminate the ISC, which TB can I use? I want to know what my options are, makes getting another one much easier 1G only? or others work?How about oil cooler? whats my option? 90 oil cooler with filter housing? is there any other setup? such as
- Unstable idle help. Oldskoolers and troubleshooters PLS.
B, when stripping and manually extending the ISC while mounted on the Idle control block it closes the orifice but doesn't seal completely Is this normal? I tested using Carb cleaner and there was a slow but pronounced leak C, The throttle stop screw is wound in tight even with this it's sitting at 2 5K
- ISC clamp - galantvr4. org
If the ISC can't react fast enough, it won't catch them in time It might not be as difficult as you think to tap a nipple into the FAIV to port air into it from pre-compressor You would just then have to block off the port on the TB that normally supplies air to the ISC
- where to ground? - GalantVR4. org
Apr 21, 2013 Newbies Replies 8 Views 3K Apr 23, 2013 tintoy ISC open too much during idle mjdarg Jul 30, 2015 Newbies Replies 6 Views 2K Aug 1, 2015 prove_it 2g biss manitousxti Nov 26, 2009 Newbies Replies 3 Views 2K Nov 29, 2009 - ground control coilover question conradical Feb 16, 2012 Newbies Replies 6 Views 5K Feb 18, 2012 turbowop Support
- Hunting Idle on Hot Start is driving me nuts! - GalantVR4. org
Finally since the ISC is old it could be faulty I purchased a new ISC but it seems the JDM and USDM ISCs are different so I am stuck with the old ISC at present Any of these issues could technically be the source of the problem but I really need to know why any of them would only cause an issue on a hot start and not on a cold start
- How much should I offer for this eprom? - GalantVR4. org
Now, I wanted to use this on a year-round car, and I think I'll be ok without the ISC, and I'm trying to get this for cheap He wants me to make an offer and I have no idea How much is an eprom with a blown ISC driver circuit worth?
- isc not working - GalantVR4. org
So replaced the ISC after my last ecu blew a driver, I replaced the ecu and rewired the pump as some of you may remember, I have a bad idle surge now, and I adjusted the biss all the way in and still idles and fluctuates around 12-1600 rpms, The ISC I pulled out to see if it'd move with the key
- Idle Issues. . - GalantVR4. org
So I'm trying to get my new Galant all squared away and next on the list is this pesky idle I tested the pins on the ISC and they're all reading around 29 ohms, which is apparently good What happens is the car will fire up and idle pretty good, but it will sometimes drop idle and pick back
|
|
|