|
- AC Delco R45TS gap out of the box - Team Chevelle
It's SOP to inspect gap new spark plugs to your desired gap before installing them They could have been dropped, thereby changing the gap, etc NEVER assume they are gapped correctly out of the box How does the manufacturer know what YOU are going to gap them at? David 1966 Fremont 11A, SS396 L35 coupe - 1 of 66,843
- Stihl Ignition Module Air Gap. . . - Arborist, Chainsaw Tree Work Forum
Here's the problem, the stihl setting gage seems to set the air gap too tight, like 0 004" measured between the ignition module arms and the flywheel magnets using a feeler gage set It seems as though the center coil pick up on the ignition module has a wider air gap Now my question, what is the proper way to measure an ignition module air gap?
- 026 Ring gap. Too much? - Team Chevelle
Building a 454 030 overbore and pre gapped rings are 25 26 thou gap That is a bit more than I would like Mild street build Naturally aspirated ok, or do I have to buy file fit that cost a fortune? Will this gap give too much blow-by?
- Spark Plug Gap - BBC - Team Camaro Tech
Things that determine resistance is the plug wire conductor (metal conducts better than carbon impregnated fiberglass strands), the spark gap, and the resistance in the plug (the R in the designation of an AC-delco plug denotes an internal air gap to prevent power from bleeding off too soon)
- Torque Converter to Flywheel Clearance - Team Chevelle
TH350 Stock converter to a BluePrint 350 w BP Flexplate (new) I have done the research and just wanted to confirm what I have read online with the knowledge base here When I go to bolt the TC and the flywheel together, there is a gap of 210 as measured with feeler gauges (see pic below)
- Spark plug gap. - Team Chevelle
I'm not sure what gap my spark plugs should be I have a 10 to 1 compression 496, iron heads that were redone with bigger valves etc by a pro engine builder I'm using Pertronix flame thrower distributor
- MSD 6AL Spark Plug Gap - Team Camaro Tech
The plug gap is a little small for that mild of a motor I would run @ 0 045"-0 050" In fact when I first started running MSD ignitions It was a 6al box with a pro-billet dist an a 350 built up not much more than yours, and I ran a 0 045" plug gap for 3 yrs I think the example from MSD below is a little wide in my opinion
- Flywheel gap??? | Arborist, Chainsaw Tree Work Forum
The business cars gap is the quickest way of setting and will be fine As for the tape on that fly wheel I have never seen anything on any flywheel like that on any machine from large to small I have worked on If you bought the saw second hand maybe that was the previous owners way of setting the gap?
|
|
|