|
- Rocker arm fulcrum - Ford Power Stroke Nation
Once I have my heads in place, push rods in Do I torque the rocker arm fulcrums down then torque the arp head studs second? or the other way around? Appreciate any help
- Rocker arm replacement - Ford Power Stroke Nation
I have a fairly new to me F450, had 90k on it when I bought it, approaching 100k, and I want to replace all the rockers and the bridges, maybe the pushrods too for reliability and to address the issues these engines have Two things I question Does the fuel rail HAVE to come off? Meaning I have
- TABLE OF CONTENTS - Ford Power Stroke Nation
Torque only fulcrum plates #1,2,7,8 per steps 4-6 If #8 intake pushrod shows cam lift, this is the #4 firing position Torque only fulcrum plates #3,4,5,6 per steps 4-6 Step 4: Partially run down both M10 bolts until they just contact the fulcrum plate Step 5: Fully run down and torque inboard (upper) bolt to 45 lb ft (62 Nm)
- what is the cause of the 6. 0 lifter failure - Ford Power Stroke Nation
With the rocker back in place with the ball, brand new retaining clip and fulcrum tightened down, you can reach in and remove the valvebridge Scanner only showed a fault in cylinder 8 Here is a short video of the rocker and valvebridge
- torque specs and sequence for mains - Ford Power Stroke Nation
Rocker arm fulcrum plate 31 23 — Glow plugs 19 14 — ICP sensor 12 9 — Oil rail assemblyb — — — High pressure tube (case to head) 45 33 — Oil rail check valve 34 25 — Oil rail vent plugs 11 8 — 2003 Excursion, F-Super Duty 250-550, 1 2003 303-01D-4 Engine — 6 0L Diesel 303-01D-4 SPECIFICATIONS (Continued) Torque
- 2000 ZF6 clutch Issue | Ford Power Stroke Nation
Hey guys, Got a 2000 F250 with a Dual disk south bend clutch and as of lately its been getting hard to put into gear The clutch has no more than 5000 miles on it Also the clutch fork is very loose, it will move side to side and up and down a good bit Im thinking maybe a bent fork or bad throw
- SECTION 303-01C Engine — 6. 0L Dies - Ford Power Stroke Nation
Apply clean engine oil to the O-ring seal before installing
- air filter thumping - Ford Power Stroke Nation
It's very likely the stamped rocker broke either at the fulcrum point or the cup failed I have seen this a few times and it's always been either a pushrod or rocker failure and the valves are fine
|
|
|