|
- What defines a euro clear? | Southern Polyurethanes Forum
What is the definition of a "euro" clear? Most companies seem to offer one, I suspect it's somewhere in the middle of a top-of-the line clear and a production type clear but it's not clear :) to me Solids? time to buff? What is "euro" about it?
- Euroclear | Southern Polyurethanes Forum
Euroclear Thread starter 3rdelke; Start date Jun 29, 2024; 3 3rdelke New Member Jun 29, 2024 #1 I have
- Questions about SPI Euro clear - Southern Polyurethanes Forum
Hey guys, been a member for a while but never posted, and was wondering if anyone could help me out I'll jump right to the questions and make an into below in case anyone wants to skip it Is the Euro clear alot harder than the universal? How long is the activator good for once opened? Can you
- Isnt Matrix Just PPG - Southern Polyurethanes Forum
good to see you back jim ! i was talked into the matrix system by a relative in sales used the entire system down to the euroclear both cars chipped badly and had to be rebuffed several times i used the epoxy on a 57 convert that i blasted now a year or so latter there is surface rust coming through all over the car which now that i think about it makes it just like ppg dplf i know the
- production clear vs. euro clear | Southern Polyurethanes Forum
Jeremy, I have sprayed both - About a gallon of the 2 1 Production and several gals of the 5000 Euro The Euro for me is a little easier to match a factory peel with
- What Are These Spots? | Southern Polyurethanes Forum
I just finished painting my jambs and door edges Used Wandabase and Euroclear over 1:1:1: epoxy sealer (gray) Just to back up a bit, I am a novice at this I have used epoxy primer before and sprayed some base and clear but it's been awhile So after 2 coats of base yesterday I sprayed two coats of clear this morning
- Which clear to use?? - Southern Polyurethanes Forum
SPI Universal Clear It is a very high quality clear One of the best clears out there And it's affordable as well
- How Do I Safely Buff These Areas? | Southern Polyurethanes Forum
Thank you everyone for the suggestions I used a combination of everyone's suggestions Protected feature lines with tape, angled the buffing pad, and ultimately found a 3" buffing pad and backer that fits my right angle drill
|
|
|