|
- Best Dremel Attachment For Removing Hard Rock? - The Fossil Forum
Just got a Dremel and am trying to use it to clean fossils I found What Dremel heads and speeds work best for removing hard rock deposits to expose fossils?
- Advice for Dremel engraver fossil prep - The Fossil Forum
I have recently begun my journey into fossil prep, i'm using a dremel electric engraver as it seemed to be the best cheap tool I have several ammonites from Yorkshire within nodules - these are very hard in the centre and consist of pyritised sediment It is taking a very long time with the drem
- Any Tips On How To Use A Dremel To Clean Fossils?
Today I bought my first dremel I saw a post that said to use a wire brush , but will that damage the fossil?
- Dremel engraver fine tips - Fossil Preparation - The Fossil Forum
I just wanted to give a product recommendation here I was looking for a finer tip for my Dremel engraver so I could work on smaller areas without fear of damage I was recommended this guy (from our favorite auction site) by a fellow member I was a little skeptical at first since it's hand craf
- Chemical Dremel 290 prepping a partial ammonite
Before I start, here's the disclaimer, caveat and warning : " Danger, Will Robinson, Danger! " Muriatic acid is harmful if used incorrectly There, I feel better now This particular partial ammonite is from the Late Cretaceous Period (Campanian) of the inland sea which was in southeastern Utah
- Buffing Polishing Shark Teeth - With A Dremel - The Fossil Forum
I have a Dremel and the polishing wheels, and a friend even told me to try using Q-tips with toothpaste The biggest problem I have is being able to hold onto the tooth while trying to touch the Dremel to it If the polishing wheel grabs the tip or an edge, it flings the tooth across the room
- Trilobites_are_awesomes trilobite preps. - The Fossil Forum
Here are some of my trilobite preps! I only have a Dremel and Hand tools so I'm a bit limited Enjoy! James This one was found (not by me) disariculated one the same rock and a remounted the head back on the thorax! It's an Eldredgeops crassituberculata Before: After:
- Horn Corals, Brachiopods, and a Gastropod Walk into a Spillway… (Caesar . . .
Dremel 290 Engraver ( not the rotary Dremel ) with Zoic Tungsten Carbide styli Stone-grade tungsten carbide tips are what make the D 290 into a prep tool The factory nib is a dull butter knife in comparison @SPrice Thanks so much! And thank you for the recommendation! Amazon doesn't seem to have this available
|
|
|