|
- Problems with clients receiving DHCP addresses : r sysadmin - Reddit
These DHCP service was running on each of our two domain controllers In load sharing mode the DHCP server hashes the mac address then either ignores the mac address, or accepts it based on some mutually exclusive factor so that if one server ignore is, the other responds
- MX100 - Convert existing DHCP lease to reservation? : r meraki - Reddit
If the client gets its DHCP from the MX100 which it sounds like it does then go to the clients description detail page and change its lease from dynamic to static
- How is DHCP reservation different from assigning a static IP?
So basically DHCP reservation is done from your DHCP server (router) and thus making sure that your device gets the same IP every time and there are no conflicting IPs Manually assigning static IPs does the same thing but could cause issues if you assign the same static ip to 2 machines Is that correct?
- Turn off DHCP on Google WiFi to use another DHCP Server : r . . . - Reddit
17 votes, 25 comments trueYou can't turn the dhcp completely off but what you can do is set the dhcp pool to 1 address and set a reservation for that address Once that address is assigned it will not hand out additional addresses I have the reservation set to the IP of my raspberry pi which is running pi-hole with dhcp turned on
- DHCP BAD_ADDRESS : r sysadmin - Reddit
The DHCP server won't hand out addresses that respond to pings, so there won't be any duplicates from DHCP clients Windows 9x used to do a Gratuitous ARP on the client side, whether configured statically or as a DHCP client, when the TCP IP stack was initialized, and then banner up a nice diag message containing the conflicting MAC address
- DHCP issues Continue : r UNIFI - Reddit
I ended up turning off DHCP Snooping in UniFi and the problem immediately cleared up Literally, within 90 seconds of turning this off all buildings were back on and running normally again
- DHCP Server Best Practices : r networking - Reddit
Hi everyone, I have a few questions about DHCP and how to deploy a DHCP cluster on Windows Server; and what the best practices are for this I have read many articles describing best practices, but they leave out a lot of details Also, only few guides describe the deployment for a large organization: 10 000+ devices Is is best practice to automate failover replication with a cron job? The
- Strange DHCP Issues : r fortinet - Reddit
Windows clients always to renew DHCP leases at half of the lease duration, so you scan check on your DHCP server leases table and idenfy any client with issues to renew the DHCP lease in advance
|
|
|