- HUSQVARNA - New saw leaking oil | Outdoor Power Equipment Forum
I purchased my first chain saw about three months ago - Husqvarna 450 Rancher Used it once and put it away today I see oil has run out of the bottom of the case it's in Took it out of the case, cleaned the oil off the bottm, but can't tell where it's coming from I assume it's chain oil? Any
- For the experts, what do the different angles do?
Some guys are stuck in a ' one-chain-on-one-saw ' mindset, filing on the bar, and using a chain up before removing it I like to think of my saws like a socket set: power heads = ratchets (1 4", 3 8", 1 2" drive) guide bars = extensions chains = sockets (deep, 6 point, metric, etc ) Choose what you need for the task at hand
- stihl 192t starts,runs for a bit ,then dies? - Outdoor Power Equipment . . .
Got a low hour 192T that,from cold start,fires on choke after two pulls,then runs first pull no choke runs well for about 20 30 seconds then dies Starts,then dies straightaway,then wont start any diagnosis welcomed!
- Dukes saw chain - Outdoor Power Equipment Forum
So I've been running 24" loops of the Duke's chain for the last couple of weeks and really like it It's good chain, especially for the price - It comes with a Husqvarna x cut like tooth profile and is very sharp and aggressive out of the box - Has the same type of first time using stretch
- Is it okay to run a chain with an extra drive link?
Hey guys, I have a bar here that's 3 8lp, 050, 56DL There's a decent sale price on some loops of 3 8lp, 050, 57DL Wondering if the one extra drive link would be okay to run?
- Best bar chain for Stihl 026 - Outdoor Power Equipment Forum
Bad ass little saw, I have four of them, and brain damage +1 I have two Stihl 026 PRO's and love them both One backs up the other, but I have never had to back them up They both always start, always run well, and never fail I suppose I could replace them both for $1,200 but that seems a bit pointless to me
- Alternative fixes for chain brake stalling engine?
The chain brake is stalling the engine, with it off the chain does not spin and the saw idles normally The clutch, drum, and needle bearing are new It looks like the crank shaft is worn enough to let the drum twist angle with the brake applied Most of the searches I've found say to replace
- Can I remove just one link to save a stretched chain that still has . . .
I have a good chain that is at the limit to tighten, but cutters have plenty of life left Will this affect the pitch enough to cause a problem?
|