|
- RCU Forums - What should be my lipo cutoff? - RC Universe
All times are GMT -8 The time now is 01:29 PM
- What’s the best cutoff voltage for a Lipo battery
The internal resistance of a good LiPo cell is typically lower than a good round cell so I agree, you will get less voltage sag with LiPo’s The tradeoff is that LiPo’s have increased volatility, shorter cycle life, and are a lot more fragile
- what should my lipo cutoff be? - R C Tech Forums
I use a 3 2v cutoff per cell, so 6 4v on my 2s lipo in my 1 10 buggies and trucks It's better to have your ESC cut off your lipo than risk getting the lipo too low in voltage, as it will be junk shortly after Set it at 3 2 or 3 4 and forget about it If you can't make 8 minutes of run time, then you have some serious issues!!
- Quick question here: what’s a safe ending voltage for a lipo when . . .
LiPO cells are safe down to 3 0v; flying to land at 3 5v cell is wasting a good 30-35% of your useable capacity Matter of fact you can't set a car esc to cut off any higher than 3 3 for the most part
- Minimal safe voltage for 2S lipo - RC Groups
Discussion Minimal safe voltage for 2S lipo Batteries and Chargers
- What is a safe Lipo cutoff voltage? – MullOverThing
What is a safe Lipo cutoff voltage? 3 0V is usually considered too low these days 3 3 or 3 4 is a more accepted number 3 3 and 3 4 is only accepted for those who accept sub par lipo’s or use a lipo that is not adequate for the application Really 3 0v cell is more than enough if the lipo you have is adequate for your application
- Lipo cutoff, Voltage or Capacity - R C Tech Forums
Electric Off-Road - Lipo cutoff, Voltage or Capacity - I read most places that lipo cutoff should be 3 0 volts per cell maximum I have also read in one place to only discharge them to like 80% of capacity
- 3S Battery - Lowest safe voltage? (i. e. when should I land?) : r . . .
I've been reading lots about LiPo batteries but it seems like there are also a lot of different opinions I'm using a Naze32 with the built-in voltage sensor, so what should I set my voltage alarms for? I've read that 3 0v per cell (9 0v total for 3S) is the absolute lowest safe voltage and discharging below that will harm the battery Should I set a voltage alarm at 3 5v (10 5v total) and a
|
|
|