|
- how do i test the orange wire??? | Blue Traxx Forum
The CDI box is sending its 12V pulse to the coil, as it should, but the coil is unable to properly transform it Nothing, or an inconsistent blink of the test light, indicates that your ignition coil is not recieving its proper trigger pulse from the other components of the bike's ignition system
- Cdi wiring help - Blue Traxx Forum
My CDI box has 12 wires and I believe it is a 90-95 also my stator has 7 wires please any help is much appreciated a CDI box wiring diagram with wire description particularly would be awesome Thanks
- Yamaha Warrior replace CDI with MSD 6al | Blue Traxx Forum
Yamaha Warrior replace CDI with MSD 6al fix msd warrior 350 warrior cdi Jump to Latest 96 views 0 replies 1 participant last post by RayDon Jan 18, 2025
- Yamaha Timberwolf 250 2x4 no spark - Blue Traxx Forum
Hi folks -- new to the forum, hoping for some help Trying to get ohms readings for the pickup and stator on my 94 timberwolf… for the stator and the pickup coil Engine cranks fine, but no spark at the plug wire I replaced the ignition coil thinking the primary coil was bad after measuring
- CDI? best replacement | Blue Traxx Forum
I have stage 1 hot cam jetted carbs yoshi full off road pipe what is the best CDI to use??
- CDI Issue - Blue Traxx Forum
source generates the spark energy, which is sent to the cdi and stored the pulse coil sends a signal to the cdi as to when to dump the charge from the cdi, the charge goes to your ignition coil, where it gets ramped up and shot through the spark plug the ignition switch and or bar switch either ground out the cdi, or they complete the
- Yamaha YFM350 Raptor Warrior (87-Present) | Blue Traxx Forum
The tough, long-lasting Warrior and new Raptor 350
- Help? No spark and new stator - Blue Traxx Forum
The next day we went to start it No spark what so ever So i Thought Hmm ok the Stator, Got the new one installed it Still no spark Tested the CDI Box on my dad's 2002 Yamaha Warrior his quad started right up So CDI And Stator are just fine i tested the Stator with a Ohm Reader setting on my multi Tester i got all good Readings And i just dont
|
|
|