|
- Briggs and Stratton 17. 5 hp wont start and backfires
Hi! I have a 17 5 hp B S model number 31C707 that won't start It turns over fine and I have nice spark at the plug After cranking for a while, there's a
- B S compatibility (parts swapping) - Lawn Mower Forum
Briggs engines are in series or families with the same capacity Small Hp differences are done with carbs , big differences are done with bore stroke The easiest way to see if the heads SHOULD interchange is to check the part number of the head gaskets for each engine If it is the same the heads should interchange
- Engine locks up and wont turn over (crank) - Lawn Mower Forum
I have to rotate the flywheel back and forth to free it up at which point the starter will engage and start the engine It doesn't happen often but when it does, the starter won't budge the engine The engine is an 18 HP Briggs Vanguard It has a new battery and solenoid but the starter is original Any suggestions would be appreciated
- 18 HP Briggs Stratton I C Series, how to adjust? - Lawn Mower Forum
I need step-by-step advice and instructions to get my trusty old Briggs Startton, Twin engine (18 HP Briggs Stratton I C Series), boxer run better Now it starts okay but runs just on choke, lazy etc
- Briggs and Stratton engine runs rough sputters after it gets warm
I have cleaned carburetor, changed spark plug, got new gas, and changed flywheel key and adjusted magneto spacing The engine runs cuts entire lawn but sputters instead of running smoothly I also put stabil in gas
- Intek v-twin valve adjustment procedures | Lawn Mower Forum
What valve adjustment procedures do you use on Briggs Intek V-twins? I'm aware of the factory procedure (setting each cylinder at 1 4" off TDC), but I'm curious to know how many are actually doing this versus setting them at TDC or setting one valve when the other is all the way open
- Briggs popping - Lawn Mower Forum
So here’s the deal 2019 Briggs 33R777 0012 G1 fires right up every time Runs rough and pops at high rpm (although it won’t get nearly as high as it should) but runs smooth at low RPM I’ve both cleaned the OEM carb and replaced the carb, same issue Valve clearance is good on intake exhaust
- Briggs model # 331877-2371-G5 - Lawn Mower Forum
Boudreaux In Eunice La Lawn Addict Joined Jul 22, 2017 Threads 21 Messages 2,154 May 5, 2018 Briggs model # 331877-2371-G5 #7
|
|
|