|
- Briggs popping - Lawn Mower Forum
So here’s the deal 2019 Briggs 33R777 0012 G1 fires right up every time Runs rough and pops at high rpm (although it won’t get nearly as high as it should) but runs smooth at low RPM I’ve both cleaned the OEM carb and replaced the carb, same issue Valve clearance is good on intake exhaust Fuel is fresh Flywheel key is in place
- Ignition conversion kit for old briggs? - Lawn Mower Forum
Instead of breaking the wire off, as he suggested, I just cut the primary wire off as far back as I can reach and the install the new coil according to the instructions Take you old coil into any repair shop that does Briggs service work, with all the engine numbers and they probably have the Magnatron coil for your unit in stock
- Briggs and Stratton 17. 5 hp wont start and backfires
Hi! I have a 17 5 hp B S model number 31C707 that won't start It turns over fine and I have nice spark at the plug After cranking for a while, there's a loud backfire through the carb (loud enough that the neighbors mistook it for a gunshot) Here's what I've done so far: 1) Checked the
- How much resistance (ohms) are suppose to be on Briggs ignition coil . . .
The wires from the plug near the starter motor are Briggs engine parts and from there on it is a Murray part With the wires to the coils disconnected then only electrical thing that can kill the engine is the solenoid which is spring loaded off and held open by the grey wire The solenoid should also have ground wire as well and these give
- B S 19. 5 compression camshaft issue | Lawn Mower Forum
All of the 210000, 280000, 310000, and 330000 series OHV engines use the same camshaft but for some reason the 310000 and 330000 are the engines that these are constantly failing on Now take that with a grain of salt as these are also the most installed Briggs single cylinder rider engines so the volume of them out there is huge
- Briggs 17. 5 PROPER valve Adjustment method Debate
On a Briggs engine 0 004" is near the maximum for the inlet minimum for the exhaust So to make it easier for those who have no idea about why they are setting the valve lash or are just plain lazy, a lot of techs will use 0 004" on both
- Briggs - Gas Blowing Out of Carb | Lawn Mower Forum
Briggs Engine 127802-0640-01 95091859 Carb has primer bulb Toro Push Mower Problem-Symptoms: 1 Engine starts and runs great for a few minutes and then runs "rough" for 15-20 seconds and then runs smooth for another minute or so and then runs rough again 2 After troubleshooting, I noticed
- B S compatibility (parts swapping) | Lawn Mower Forum
Briggs engines are in series or families with the same capacity Small Hp differences are done with carbs , big differences are done with bore stroke The easiest way to see if the heads SHOULD interchange is to check the part number of the head gaskets for each engine If it is the same the heads should interchange
|
|
|