|
- Boating Forum - iboats Boating Forums
Discussion of boats, general boating questions and anything else directly related to a boat or an engine
- 2026 IHRA Outlaw Drag Boat Racing Series schedule!
2026 IHRA Outlaw Drag Boat Racing Series schedule! Hopefully at least a few more are added, it's a starting point though!
- Do I need 4x4 to launch boat? - iboats Boating Forums
Re: Do I need 4x4 to lauanch boat? Re: Do I need 4x4 to lauanch boat? If you get a locking rear end and are careful a 2wd will handle "most" ramp situations I have seen some 2wd owners carry a set of traction mats just in case It really depends on the ramp, how deep you need to launch and the surface conditions I know of some ramps that a 2wd is fine and some where a 4wd is required I have
- Mercury Mariner Outboards - iboats Boating Forums
Sponsored by UflexSwapping power head units or midsection lower units or swivel transom mounts between Mercury 83 50 HP 4 cylinder and 93 40 HP
- PARKER ENDURO BOAT RACE SATURDAY OCTOBER 25TH
Just left So stoked for them Fantastic performance for the GN 550 Team! How did your boat do clank? How many boats registered, started and finished the race?
- Boat bouncing on trailer - iboats Boating Forums
Re: Boat bouncing on trailer How does you boat ride sit on your trailer? My small trailer has rollers up down the center with bunk boards on either side One of the rollers is near the front, about as far front as it can be and still be under the boat (this is the most forward support contact point)
- How much room between boat and guide ons? - iboats Boating Forums
Re: How much room between boat and guide ons? My side bunks mount with 2" receivers welded to the trailer so positioning of the bunk is set by the amount you slide into the receiver There is a bolt with a welded nut on the receiver that sets it into position I have a similar situation with a thru hull fitting that would hit a bottom bunk
- Boat losing power at higher RPM - iboats Boating Forums
Re: Boat losing power at higher RPM I agree with bond-o, also check your low oil press sesnor wires, i had the same problem and it was loose wires at high RPM's if they are loose the fuel pump will trun off and on, loosing fuel in the carbs (if it is carded)
|
|
|