|
- Accel 25 ohm wires - NastyZ28. com
New product from Accel bought a set for the big block (part number 257040)just for grins to see if it helped get some more juice to my plugs MSD 6al with a Unilite Cleaned the plugs like new Passed the seat of the pants test as well Wires tested roughly 22 ohms on all 8 Never thought
- Which Brand of Distributor Do You Like (POLL)? | NastyZ28. com
Mallory Unilite Accel Electronic MSD GM Performance I am leaning towards the small headed distributors with external coil since I just bought a set of 8 5mm spiral core wires Any input would be appreciated I am going to buy the pick-up and reluctor for mine while putting pennies in a
- Edelbrock carb. Selecting Step up springs with a vacuum gauge
I can change jets, rods, accel pump shot and only affect the areas that those parts control but if I change the stepup springs to the wrong ones the car can become almost undriveable at times Im talking 1"Hg changes can make a big difference with those springs With 10"Hg of vacuum you must a pretty large bump stick in there
- Adding a Crane adv can on aftermarket HEI - NastyZ28. com
The Accel can rod and bracket is about 1 2" longer than the Crane unit, it just doesn't fit I made sure the reluctor is in the exact same spot as the old unit, the travel is about the same the only difference is the mounting holes and the rod length Both old and new can enter the disty at the same angle, and the rod travel is almost identical If Accel had included a different (lighter
- 1971 Camaro data - Statistics, facts, decoding, figures reference . . .
1971 Camaro Statistics, facts, decoding, figures reference information
- Fuel injection systems - NastyZ28. com
Does anyone here have any experience with the various kits available to convert a small block chevy from carb to fuel injection? I have looked at ACCEL MoTec, FAST and Electromotive They all offer kits with the ECM computer, various sensors, manifolds, injectors and plenums and each claims to
- Vortec Cylinder Heads: The Definitive Guide - NastyZ28. com
Guys, Dave "Dirt" Reynolds has suggested that we devote some space on the message board to Vortec heads Cylinder heads are arguably the most important link in the "power chain", so it is certainly worth its own dedicated area for discussion
- quadrajet question. please help. - NastyZ28. com
took of the qjet today dissassembled, reassembled with new top gasket but when putting the top back on, noticed that the "power piston assembly" was pushing up on the gasket the needles were properly aligned and guiding through the jets well but is the piston supposed to be pushing up aainst the top like that? it was holding the top bu by maybe an eight of an incho or so?
|
|
|