|
- 4WD Not Engaging - Jeep Enthusiast Forums
What would cause my 4WD not to engage (Full or Part) unless I briefly drive in reverse first? I'm taking it in for an inspection next week to the dealership, and I told them about this issue, but I'd like to point them in some general direction first
- Service 4wd system final fix? - Jeep Enthusiast Forums
"Service 4wd system" final fix? Hello All, I bought my WK in September 2016 Recently it started to show the "service 4wd" when ever I engaged 4Lo I could here the transfer motor working for a while, and it did engage 4Lo, only the message appeared
- 4wd!, ESC, abs lights light up then go away - Jeep Enthusiast Forums
4WD! Warning Light This light monitors the 4-Wheel Drive (4WD) system The light will come on, for a bulb check, when the ignition key is turned to the ON RUN position and may stay on for as long as three seconds When lit solid: There is an 4WD system fault 4WD performance will be at a reduced level Service the 4WD system soon
- 4WD System Unavailable Service Required - Jeep Enthusiast Forums
All, It's been about 4 years since I buried my WJ I've now got a 14 KL that is 3 days old to me Today the 4WD System Unavailable Service Required message popped up on the console I attached my ODB2 tool and saw zero codes pop up I found some random forums that talked about fuses, so I
- [Solved] Clunking noise from front end, differential?
I've noticed a clunking noise that sounds like it is somewhere in the front end I am suspecting it is the differential because it gets worse with 4wd
- 4WD - Explaining the 3 Systems | Jeep Enthusiast Forums
Here is an explanation of the 3 4WD systems that are used in the WK2 One is technically an AWD system, but we will not berate Jeep for calling it a 4x4
- 4WD lights stays on - Jeep Enthusiast Forums
4WD lights stays on 4wd 4wd dash light Jump to Latest 1 6K views 14 replies 3 participants last post by Rubi4MyMrs May 9, 2023
- Stuck in 4wd low - Jeep Enthusiast Forums
Then the service ,4wd light came on and the front tires stopped spinning Was able to get pulled out but the 4 low stayed on and won't disengage Neutral button is lit Quadratec system won't change modes 1 Yes I tried to unplug the battery for 30in 2 Yes I tried re setting the connections to the TCM under the driver's seat Please helpppppp
|
|
|