|
- What cars came with what superchargers? | 3800Pro Forums
The third gen M90 was changed slightly for 1998 (minor changes such as vacuum ports), and then remained the same through 2003 in the same vehicles, all of which came stock with the 3800 Series II engine and 4T65E-HD transaxle
- 3800 series 1 oil pump - 3800Pro Forums
3800 series 1 oil pump Jump to Latest 1 9K views 4 replies 3 participants last post by Riviera90 Oct 29, 2011 R
- No Oil Pressure after Timing Cover-Oil Pan-Engine Mount. . .
Got the seal in in a very cleaver way, no pounding ! I got a National seal 710162 for the 3800, funny you should mention getting the same for your rear oil seal, yes they are the best and part of the Federal family which includes Felpro This seal is the 3500 style , no flat outer lip that sits on the timing cover
- IAC valve? | 3800Pro Forums
Recently the Toronado started stalling, A LOT It happens either at a dead stop or coasting at low speed, 25-35 ,mph I had this same problem last year and pulled and adjusted the IAC valve and that seemed to have fixed it It started again the other day but about ten times worse Is the IAC
- random misfiring issue - 3800Pro Forums
CAR: a 98 grand prix gt 3 8 157k miles ISSUE: p0300 -random multiple cyl misfire, p0306 -cyl 6 misfire some stalling at idle HISTORY: car sat for a lil over a year, i bought it with a 153k miles 3 months ago it needed a battery, starter, all new steel brake lines and the 12v ign feed to
- New coils, Icm and crank sensor still no spark - 3800Pro Forums
I changed my ignition coils out and put the new ones on and now I have no spark I changed the icm thinking it was that and still no spark so doing some research found out the crank sensor goes bad common problem so I changed that and still no spark car will turn over but wont fire any
- Max Horsepower from 3800sc - 3800Pro Forums
I'm currently doing some research and looking to swap a 3800sc into a Fiero and I want to know what's the most horsepower you can get out of these 3 8 series 2 engines with still running a supercharger I want around 400-500rwhp and don't mind spending a couple grand on mods getting it there
- 97-03 Grand Prix Torque Specs - 3800Pro Forums
Hpping a Mod could Sticky this I just got off the phone with WBody Store and they emailed this to me Figured it could help everyone out STICKY STICKY please TORQUE SPECS FOR 97 2003 Accelerator Control Cable Bracket Bolt 16 Nm (12 ft lbs ) Balance Shaft Driven Gear Bolt 22 + 70?Nm
|
|
|