|
- defective Auto zone part damaged my car any advice??
I buy parts from autozone, they are a parts house who advertise as themselves towards catering to backyard mechanics If they sell a defective part to a backyard mechanic I do not believe they can just say "well we do not stand behind these parts unless you are a credited shop " My business and loyalty is with autozone not the manufactuer
- Autozone Duralast wheel bearing = Timken? - Jeep Enthusiast Forums
Auto zone is the ONLY big name auto parts store that carries any Timken bearings here that I could find, on the shelf That surprised me They wanted to sell me a genuine Timken outer race and pair it up with the Duralast cone bearing They claimed the Duralast was Timken re-branded
- Autozone Remanufactured engines - how good - Jeep Enthusiast Forums
I'd like to hear from people that have an Autozone reman engine or know someone who has one Pros and Cons How much did you pay?
- Heater Core Flush DIY w photos - Jeep Enthusiast Forums
I'd be happy to add change any parts of this if people have suggestions that have worked for them As always, PLEASE DISPOSE OF COOLANT AND ALL VEHICLE FLUIDS APPROPRIATELY MOST AUTOZONE ADVANCE AUTO PARTS STORES WILL DISPOSE OF YOUR FLUID IF YOU BRING IT TO THEM IN AN APPROPRIATE CONTAINER Happy Jeepin! :wave:
- PCV solenoid valve? - Jeep Wrangler Forum
Finding a replacement PCV solenoid valve connector for a 1988 Jeep YJ with a 4 2L I6 engine can be challenging as the part is likely no longer manufactured Your best bet is to search for used parts at Jeep salvage yards Some suggested online resources include J W Auto Wreckers, Jeep Unlimited, Dead Jeeps, and Partsbreakers When searching, use the part number 33000722 Be aware that later
- Anybody know how long I have to return my core (engine) to autozone ?I . . .
Anybody know how long I have to return my core (engine) to autozone ? I'm scared to ask because it's been a minute, so to speak
- Cest le monde à lenvers!! -AutoZone Québec, le forum de Essai-Auto. com
C'est le monde à l'envers!! by Viber » Mon Jul 22, 2013 3:58 pm Mes pads de frein avant sur le Flex sont fini raide Donc je magasine un peu voir combien ça va me couter Auto part 1 (Duroy): 93 69$ Auto part 2 (NAPA): 120 69$ Dealer Ford: 79 95$ + garantie à vie!! Non mais, est où la crosse??
- ¿Cómo purgar el embrague por ti mismo? | Jeep Wrangler Forum
To bleed your clutch by yourself, several methods are suggested: * **One-way valve kit:** Purchase a kit with a one-way valve from an auto parts store * **Gravity Bleeding:** Open the bleeder valve until fluid drips out, ensuring the master cylinder stays full Repeat as needed until the pedal feels right * **Board Method:** Use a board to hold the clutch pedal down, pressurizing the system
|
|
|