- ESR-4266 - HILTI, INC.
7 1 The ICC-ES mark of conformity, electronic labeling, or the evaluation report number (ICC-ES ESR-4266) along with the name, registered trademark, or registered logo of the report holder must be included in the product label
- ESR-4266 - Hilti, Inc.
The design, installation, conditions of use and labeling of the Kwik Bolt TZ2 (KB-TZ2) anchors are in accordance with the 2018 International Building Code® (2018 IBC) provisions noted in the evaluation report ESR-4266
- Home - ICC Evaluation Service, LLC (ICC-ES)
Home - ICC Evaluation Service, LLC (ICC-ES)
- ESR-4266 - HILTI KWIK BOLT TZ2 CARBON AND STAINLESS STEEL ANCHORS IN
The Building Products Circle is a community of building products DIY, installers, specifiers, dealers manufacturers with a purpose of collaborating, learning, and networking
- ICC ESR 4266 KB TZ2 Expansion Anchor Concrete Approval
ICC ESR 4266 KB TZ2 Expansion Anchor Concrete Approval This document provides an evaluation report for Hilti Kwik Bolt TZ2 carbon and stainless steel anchors in cracked and uncracked concrete
- drill bit for KB-TZ2 anchors - Drill Bit, ESR-4266 - Hilti USA
ESR-4266 only lists TE-YD or TE-CD drill bits with a Hilti vacuum Referencing Step 1a in Figure 7 of ESR-4266, a standard hammer drill bit may be used to install the KB-TZ2 The KB-TZ2 does not require hole cleaning when using this drilling method, but it can be done if desired
- ESR-2024 - DEWALT - ICC Evaluation Service, LLC (ICC-ES)
Section number references in this report are for the 2024 IBC and IRC and the standards referenced therein Corresponding section numbers for earlier code editions are shown in Table 9 at the end of this report
- KB TZ2 ESR 4266 Torque values - Hilti USA
Can the listed torque values in ESR 4266 be exceeded and by how much to use the listed values in the report Expansion anchors, such as the Kwik Bolt TZ2, rely on torque to expand wedges to ensure expected capacities are met Hilti does not have any data on over-torqued installation
|